SCIFIT DC1000 Guide d'installation télécharger pdf (Page 25)

F. Test Mode

The Test Mode provides technicians with additional information for use in

troubleshooting the DC1000 treadmill. Turn the power switch on the treadmill to

the OFF position. Press the ELEVATION UP arrow and the ELEVATION DOWN

arrow, and simultaneously turn the treadmill power switch to the ON position.

Continue to press ELEVATION UP and ELEVATION DOWN throughout the

entire power up process and until “tESt” appears in the center display. This

process will take three (3) seconds.

1. Display test

Press any button. The first test will illuminate each individual segment of all three

(3) displays in a race track pattern. The LED to the sides of the top display as

well as the LED between the heart symbols will be illuminated in turn. Press any

button. The second test will illuminate the number “8” in sequence for all the

displays and then illuminate all the LEDs. Press any button. The third test will

illuminate all the displays and all the LEDs and keep them all on. Press any key

to end the test and advance to the Switch test.

2. Switch Test

“S” and “I” will be shown in the top display. The second number corresponds to

the switches as shown in the table below. Press the appropriate switch for the

number displayed. If the switch functions properly, the number in the top display

will advance. The number in the top display will be shown in the sequence listed

in the following table and the switches must be pressed in this sequence. If the

switches are not pressed in this sequence, the test will not advance.

Number Switch

1 Start 6 Elevation Down

2 Stop 7 Speed Up

3 Scan 8 Speed Down

4 Select 9 Heart Rate Up

5 Elevation Up 10 Heart Rate Down

3. Grade Test

When the Switch test is complete, the system will automatically advance to the

Grade test. “GrAd” will be shown in the top display. This test removes the

software from the elevation control system. It utilizes only the hardware of the

system. Press the ELEVATION UP arrow only or ELEVATION DOWN arrow

only to determine if the elevation system is working properly.

WARNING: Do not press both the ELEVATION UP and ELEVATION DOWN

arrows at the same time – severe damage will result!

The speed display will show “UP” or “dn” depending on whether the treadmill’s

elevation is going up or down. The elevation display will show the scale that is

used by the software—high numbers when the treadmill is down and low

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 61 62

Pas de commentaire

SCIFIT DC1000 Guide d'installation Page 25