SCIFIT DC1000 Guide d'installation télécharger pdf (Page 45)

the roller threads. Rotate the right side of the front roller (A1244) under

the deck and running belt. This will loosen the motor’s timing belt on the

left side of the front roller and make it easy to slide off. Rotate the front

roller approximately 90º from its original position. Pull the roller out from

under the treadmill.

7. Install new front roller by reversing step 6.

8. Install guide rollers.

9. Turn each rear roller tension bolt clockwise, approximately 6-10 turns.

10. Tension running belt according to the “Running Belt Tracking and

Tensioning” procedure (Page 34).

G. Rear Roller Replacement

1. Elevate the treadmill to 15% grade.

2. Unplug treadmill from the wall outlet. Treadmill will remain elevated.

3. Using a Philips screwdriver, remove the motor hood (P1252).

4. Using a 5/16” Allen wrench, turn each of the rear roller tension bolts

counterclockwise, approximately 6-10 turns to relieve tension from the

running belt.

5. Remove both guide rollers (P1242), using a ½” wrench.

6. With a 9/16” wrench, remove the left side, front roller bolt. Loosen the

right side, front roller bolt far enough to disengage the bolt threads from

the roller threads. Rotate the right side of the front roller (A1244) under

the deck and running belt. This will loosen the motor belt on the left side

of the front roller and make it easy to slide off. Rotate the front roller

approximately 90º from its original position. Pull the roller out from under

the treadmill.

7. Place a solid object under the rear cross member (P1513) of the treadmill

(i.e. tool box, stool, cinder block, etc.).

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 61 62

Pas de commentaire

SCIFIT DC1000 Guide d'installation Page 45